Contact With Liquid - Gigaset a220 User Manual

Problem
No wireless connection to the
base station, Base flashes in
the display.
You cannot hear a ringer/dial-
ling tone from the fixed line
network.
Error tone sounds after system
PIN prompt.
PIN forgotten.

Contact with liquid

If the handset has come into contact with liquid:
1 Switch off the handset and remove the battery pack immediately.
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with the battery compartment open and the keypad facing down in a dry,
warm place for at least 72 hours (not in a microwave, oven etc.).
4 Do not switch on the handset again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.
Environment
Our environmental mission statement
We, Gigaset Communications GmbH, bear social responsibility and are actively committed to a better world. Our ideas,
technologies and actions serve people, society and the environment. The aim of our global activity is to secure sustain-
able life resources for humanity. We are committed to a responsibility for our products that comprises their entire life
cycle. The environmental impact of products, including their manufacture, procurement, distribution, utilisation, service
and disposal, are already evaluated during product and process design.
Further information on environmentally friendly products and processes is available on the Internet at
www.gigaset.com.
Environmental management system
Gigaset Communications GmbH is certified pursuant to the international standards ISO 14001 and ISO 9001.
ISO 14001 (Environment): Certified since September 2007 by TüV SÜD Management Service GmbH.
ISO 9001 (Quality): Certified since 17/02/1994 by TüV SÜD Management Service GmbH.
Disposal
Batteries should not be disposed of in general household waste. Observe the local waste disposal regulations, details of
which can be obtained from your local authority.
All electrical and electronic equipment must be disposed of separately from general household waste using the sites
designated by local authorities.
If a product displays this symbol of a crossed-out rubbish bin, the product is subject to European Directive
2002/96/EC.
The appropriate disposal and separate collection of used equipment serve to prevent potential harm to the
environment and to health. They are a precondition for the re-use and recycling of used electrical and elec-
tronic equipment.
For further information on disposing of your used equipment, please contact your local authority or your refuse collec-
tion service.
Authorisation
This device is intended for analogue phone lines outside the European Economic Area (with the exception of Switzer-
land) depending on national type approval.
Country-specific requirements have been taken into consideration.
We, Gigaset Communications GmbH, declare that this device meets the essential requirements and other relevant reg-
ulations laid down in Directive 1999/5/EC.
A copy of the Declaration of Conformity is available at this Internet address:
www.gigaset.com/docs
Cause
The handset is outside the range of
the base station.
The handset is not registered.
The base station is not turned on.
The phone cord supplied has not
been used or has been replaced by a
new cord with the wrong jack con-
nections.
The system PIN you have entered is
incorrect.
!
10
Solution
Move the handset closer to the base station.
Register the handset
Check the mains connector on the base station
¢
page 3.
Please always use the phone cord supplied or
ensure that the pin connections are correct
when purchasing from a retailer: 3-4 assign-
ment of telephone leads/EURO CTR37.
Reset the system PIN to the default 0000
¢
page 8.
All handsets are de-registered. All settings are
reset. All lists are deleted.
¢
page 7.