Connection Confirmation With The Pc - Pioneer CDJ-2000 Service Manual

5

5.6 CONNECTION CONFIRMATION WITH THE PC

[1. USB B connector]
Whether communication between the PC connected via the USB B connector and this unit is properly performed or not can
be confirmed on the PC.
Note: Installation of the driver software is not necessary.
Use Device Manager for checking.
If the PC and this unit are properly connected, the components of this unit are added in Device Manager (under Hardware)
as devices.
If all components are properly displayed, the PC and this unit are properly communicating via the USB connector.
In a case of Windows XP:
Start, Control Panel, System, Hardware, then Device Manager
Devices to be added:
Universal Serial Bus controllers
USB Composite Device
Under "Sound, video and game controllers"
USB Audio Device
Human Interface Devices
HID-compliant device
USB Human Interface Device
A communication check may be easily performed if connection is
made with Device Manager displayed on the PC screen.
[2. LINK]
Whether communication between the PC connected via the LINK connector and this unit is properly performed or not
can be confirmed on this unit.
Note: Use a Category 5 cable or a cable with higher specifications for connection.
Either a straight or cross LAN cable can be used when the unit is directly connected with the PC, but when the unit is
connected with the PC via a hub, be sure to use a straight cable.
Use the MENU/UTILITY key of this unit to check linkage.
The linkage between the PC and this unit can be confirmed with LINK STATUS under [MENU/UTILITY].
How to display LINK STATUS
1. Hold the MENU/UTILITY key pressed for at least 1 sec.
The [UTILITY] screen will be displayed.
2. Select LINK STATUS, using the rotary selector.
3. With LINK STATUS selected, connect the PC and this unit, using the LINK cable.
4. Check the LINK STATUS display.
1 Not connected
Indication NOT CONNECT
If the indication changes from 1 to 2 then 3, the link is properly established.
If the cable is disconnected, the indication returns to 1.
5. After checking is completed, press the MENU/UTILITY key.
The screen displayed before the MENU/UTILITY key was pressed will be restored
5
6
2 While connection is being made
CONNECTING
CDJ-2000
6
7
3 When connected properly
CONNECTED
7
8
A
B
C
D
E
F
43
8