Load Current - Garmin MX20 User Manual

Detailed Operation
Select Airport
The Select Airport operation allows the airport of interest
to be selected from a pop-up list. The airports presented in
the list are determined based on the final destination
waypoint as the first entry, and a nearest type search for
the remaining entries. This method allows the airport to
be quickly located based on the current flight plan on the
external GPS navigator.
Once the airport is located, the Select Chart menu is
presented (see below), allowing a specific chart for that
airport to be either loaded or simply viewed.
Select Chart
The Select Chart operation allows the list of charts for the
currently selected airport to be listed in a pop-up list.
Within this list, a circular earth symbol indicates that the
chart is geo-referenced and therefore can be loaded for use
as an overlay on the maps. If a red "X" is presented
through the earth symbol, then that specific chart is not
geo-referenced and can be viewed, but not loaded as a
map overlay.
Select Loaded
The Select Loaded operation allows the currently loaded
chart to be selected for viewing. This is typically done if a
given chart was from the Custom/IFR Map, and
LOADED
viewing it from the Chart View Function is desired. Note
that loading a chart from the Custom/IFR Map will also
load and select the chart for viewing.

Load Current

The Load Current operation allows the current (viewed)
approach chart to be set as the loaded approach chart.
When this operation is performed, any previously loaded
chart is replaced with the chart that is currently being
viewed.
95