Change Access Channel; Change Access Transmit (Tx) Power - Polycom BelAir50 Configuration Manual

PN: 1725-36065-001_D.doc
Change access SSID
The following commands display and change the access SSID. In the
example, below, the first SSID is set to "Data" to be used for data
traffic and the second SSID is set to "Voice" for voice traffic. The
second voice SSID is assigned to VLAN 100.
/# cd /radio
set arm1 ssid "Data" ssidx 1
set arm1 ssid "Voice" ssidx 2 vlan 100

Change access channel

The following commands display the channel setting and change the
access radio channel to 11.
/# cd /radio
/radio# show arm1 physical channel-number
/radio# set arm1 physical channel-number 11

Change access transmit (tx) power

The following commands display and change the transmit power
setting.
/# cd /radio
/radio# show arm1 tx power
/radio# set arm1 tx power 2
The transmit power setting is determined by coverage requirement,
antenna choice, and regulatory requirements. The setting is set by
BelAir field engineers or BelAir's VARs, and they have been
properly trained to set this appropriately.
Set WPA-PSK for access
The following commands enable/disable the WPA-PSK for the voice
SSID (ssidx 2).
/# cd /radio
/radio# set arm1 wpa1 psk <Pre-Shared Key> ssidx 2
enabled
/radio# set arm1 wpa1 ssidx 2 disable
BelAir Networks: BelAir50, BelAir100, BelAir200
7