Setting Up & Connections; Installing The Holder Arm To The Projector Head - NEC NC2500S DLP CInema Installation Manual

2.
Setting Up &
Connections
This section describes how to set up the touch panel and how to connect it to the DLP
Cinema Projector.
2.1

Installing the Holder Arm to the Projector Head

[1] Remove the top front cover
from the projector head.
Remove four hexagonal fasteners from
the top to remove the front cover (lens
side).
[2] To install the touch panel to
the rear of the Projector /
lens, remove the top rear
cover from the projector head.
Remove the two hexagonal fasteners
from the top of the projector.
When removing the top rear cover, the
cable must be disconnected from the rear
status indicator. Refer to the Projector
Installation Manual "NC2500S" for further
information.
B-9