Table of Contents
Advertisement
CORRECT LOG PLACEMENT IS IMPORTANT TO PREVENT SOOTING!
The vacuum-formed ceramic logs are extremely fragile. PLEASE HANDLE CAREFULLY.
Small chips on the logs can be covered up using the touch-up paint supplied with the stove.This appli-
ance has been supplied with external shutter adjustments. Loosen the 3 shutter locking screws at left
side of burners. (If this appliance is a Direct Vent this is not necessary)
1. Install rear log (solid log) on log shelf
ensuring that both log shelf and log are
pressed firmly against back wall.
2. Install front log (log with openings) by
positioning over centering pins and
lowering. (Take care not to force and
cause damage to molded holes in bottom
of log.)
3. Place right twig on front and rear log
using ceramic pins and placement holes in
bottom of twig for alignment. (If ceramic
pins are too close, tilt front log forward,
do not make new holes in twigs.) Repeat
step for left twig.
4. Place ember nuggets across front of
burner.
5. Light appliance and let logs cure for 30
minutes. Adjust shutters to give good
flame characteristics.
NOTE: If flame tips have dark yellow or
black tips, shutters need to be opened.
6. After correct flame adjustment has been
achieved, cool appliance, remove twigs
and front log and tighten shutter adjust-
ment screws.
IMPORTANT: If shutter adjustment
screws are not tightened, expansion and
contraction of burner can allow shutter
to close and cause sooting.
Page 14
GB 40 I - FIREPLACE INSERT
INSTALLING THE LOG SET
#1
SHUTTER
#2
CENTERING
#3
CERAMIC PINS
#4
March 2000
Hide quick links:
Advertisement
Table of Contents
