Philips FM242 Service Manual page 11

Component-side SCAVIO
Figure 4-3 Service position SCAVIO (2)
To access the other side of the SCAVIO panel:
1. Disconnect all cables going to the SCAVIO panel.
2. Remove all screws at the connectors of the connector
plate, see figure 'Solder-side SCAVIO'.
3. Remove the three fixation screws that connect the SCAVIO
panel to the connector plate, see figure 'Component-side
SCAVIO'.
4. Reconnect the SCAVIO panel, be careful: do not make a
short-circuit!
4.3.2 VGA Connector Panel
How to remove the VGA Connector panel:
1. Squeeze the plastic pins that attach this panel to the
SCAVIO board, while you pull it carefully upwards.
2. Unplug the flat foil cable.
4.3.3 Power Supply Panel
Figure 4-4 Remove PSU
The supply panel can not be repaired by the network. As
measure points are accessible for possible re-alignment, there
is no further service-position.
To remove the panel unscrew the 9 screws (see drawing) and
disconnect the cables.
Mechanical Instructions
4.3.4
4.3.5
CL 16532099_043.eps
250901
4.3.6
4.3.7
CL 36532011_021.eps
200303
FM242 AA
Audio Amplifier Panel (only valid for "speaker"-version)
The solder-side of this panel is directly accessible. To access
the component-side, or to remove the whole panel, unscrew
the three fixation screws
LED/Switch Panel and Speakers
Figure 4-5 Service Position LED/Switch Panel and Speakers
To access or replace the LED/Switch panel and/or speakers:
1. Take the monitor from its service stand, and put it (face
down) on a soft surface (blanket or foam cushion), to
make sure that you do not damage the front glass plate.
2. Unscrew all fixation screws of the plastic back cover: five at
all sides.
3. Lift and remove the plastic back cover.
4. You can access now the LED/Switch panel and/or the
speakers.
LED/Switch panel
To measure the component-side, or to remove the LED/Switch
panel, unscrew one fixation screw (see enlarged part of figure
'LED/Switch Panel and Speakers'), and remove the panel.
Loudspeakers (if valid)
When you have removed the plastic back cover, you must
replace the speaker-box sealing foams (12nc: 3122 358
76221). This, to ensure that the loudspeakers are airtight.
Do not stretch the foam during mounting. Pay special
attention to the corners, to make sure that the foam is not
stretched and that it is pushed into the corners.
4. EN 11
Plastic backcover
Foam cushion
CL 36532011_012.eps
170303