Net Port Management Configure <Ltportname; Net Wan Pppoe Configure - D-Link DSR-150 Reference Manual

Unified Services Router
8 dead_interval
9 cost
8.40 net port management configure
<ltportName>
S.No Com mand Nam e
1 <ltportName>
2 save
3 exit
4 cancel
5 enable
6 auto_negotiation_enable
7 duplex_mode
8 speed

8.41 net wan pppoe configure

S.No Com mand Nam e
1 save
2 cancel
3 exit
4 UserName
5 Passw ord
6 AuthMode
7 Service
8 CompressionEnable
9 ConnectionMode
10 IdleTimeOutValue
11 GetIpFromIspEnable
The number of seconds that a
device’s hello packets must not have
been seen before its neighbors declare
the OSPF router dow n.This value must
be the same for all routers attached to a
common netw ork.The def aul t value is 40
seconds.
The cost of sending a packet on an
OSPFv3 interface
Description
port management configuration mode.
Save port management configuration
changes.
Save port management configuration
changes and exit current mode.
Roll back port management configuration
changes.
Enable/Disable the port status
Select this to let the gatew ay and
netw ork to determine the optimal port
settings.
Choose betw een Half Duplex and Full
Duplex based on the port support. The
default is Full Duplex for all ports.
One of three port speeds can be
selected: 10 Mbps, 100 Mbps and 1000
Mbps (i.e. 1 Gbps). The default setting is
1000 Mbps for all ports
Description
Save pppoe configuration changes.
Roll back pppoe configuration changes.
Save pppoe configuration changes and
current mode.
Set user name
Set Passw ord
Select Authentication Type
Set service name
Enable/Disable Compression Negotiation
Set Connection Mode type
Set Idle TimeOut Value (in min)
Enable/Disable GetIpFromIsp
63
CLI Reference Guide
Unsigned integer
Unsigned integer
Type and Description
Port name
Boolean choice
Boolean choice
select the duplex mode
select the speed
Type and Description
String
String
PPPOE Authentication Types.
String
Boolean choice
Boolean choice
PPPOE idle timeout Type.
Boolean choice