Display Exchange Instructions - Nokia 9101 Service Manual

CMO Operations & Logistics
Multimedia Creation & Support
Bochum / Germany

13. DISPLAY EXCHANGE INSTRUCTIONS

1.) Use SRT-6 to open the display connector.
3.) Remove the remaining LCD Display Adhesive by
using the SRT-6.
5.) Note the guide pins and the corresponding
openings before placing the UI Module on the SS-55
Domesheet assembly Jig.
7.) Remove the protection film from the LCD Display
Adhesive.
Service Manual 6101/6102/6103/6102i Level 1&2
PAGE 19 (28)
CONFIDENTIAL
2.) The LCD Display is glued to the UI Module with
the LCD Display Adhesive. Use SRT-6 to separate
these parts from each other.
4.) Use tweezers for support when removing the
carrier film.
6.) First press on the UI-Module carefully.
Then lift the UI-Module from the Jig and check if the
LCD Display Adhesive sticks correctly.
8.) Be sure that the surface of the LCD Display is
protected with a film. Note the guide pins and the
corresponding openings before placing the LCD
Display on the UI Module.
Copyright © 2005-2006 Nokia Corporation. All rights reserved.
Approved 3.0
MGR
11.01.2006