JVC DR-MH20SUJ Instructions Manual page 75

Filename [DR-MH30UJ_10Subsidiary.fm]
DR-MH30UJ_00.book Page 75 Monday, July 12, 2004 3:17 PM
Recording (DVD Deck)
The desired program cannot be recorded.
The channel position does not correspond to that in the
receiving area.
]Set the correct channel position for the receiving broadcast.
( pg. 23)
Recording cannot be made.
No disc or a disc not being compatible with the unit is loaded.
]Load a recordable disc on the unit. (
The disc loaded is not formatted.
]Format the disc. ( pg. 71)
A finalized DVD-R disc is loaded.
]Recording cannot be made on finalized discs. Load a recordable
disc on the unit.
The disc is full or does not have enough space for the title to be
recorded.
]Clear unnecessary titles on the disc or load a blank disc.
( pg. 53)
The DVD-RAM disc loaded has had its protect tab slid to the
protect position.
]Release the protect tab. ( pg. 10)
Recording (HDD Deck)
TV broadcasts cannot be recorded.
"L-1", "L-2" or "F-1" has been selected as the input mode.
]Set to the desired channel.
Camcorder recording is not possible.
The camcorder has not been properly connected.
]Confirm that the camcorder is properly connected.
The input mode is not correct.
]Set the input mode to "F-1". (
Page 75
pg. 7)
pg. 61)
Masterpage:Right+
Timer Recording
Timer programing cannot be made.
Date and time is not correct.
]Set date and time correctly. (
Timer recording is in progress.
]Timer programing can't be performed while a timer recording is
in progress. Wait until it finishes.
Timer programing recording does not start.
Date and time is not correct.
]Set date and time correctly. (
VCR Plus+ Timer Programing cannot be made.
Date and time set on the unit is not correct.
]Set date and time correctly. (
The channel position does not correspond to that in the
receiving area.
]Set the correct channel position for the receiving broadcast.
( pg. 23)
The VCR Plus+ system does not timer-record properly.
The unit's channel positions have been set incorrectly.
]Refer to "Changing VCR Plus+
reperform the procedure.
Automatic Satellite Program Recording does not start.
The DBS receiver is not connected properly to this unit.
]Connect the DBS receiver to the AUDIO/VIDEO INPUT (L-1)
connectors properly. ( pg. 50)
On the front display panel, "– –:– –" appears.
Power failure occurred.
]Set date and time correctly. (
"PROGRAM FULL" appears on the TV screen during timer
programing.
32 programs have already been timer programed.
]Clear unnecessary programs on the unit, then try timer
programing again. ( pg. 49)
The disc space does not increase when recorded titles are
cleared.
The PC's data recorded on a DVD-RAM drive cannot be cleared
on this unit.
]Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) (
TROUBLESHOOTING
75
EN
pg. 22)
pg. 22)
pg. 22)
® Setting" ( pg. 70) and
pg. 22)
pg. 11, 71)
Monday, 12 July 2004 14:10