Table of Contents
Advertisement
Filename [DR-M7EK_11Subsidiary.fm]
DR-M7EK_01.book Page 93 Friday, April 2, 2004 11:21 AM
DISPLAY SET
(The boldface settings in the table below indicate the settings at your purchase.)
8 SUPERIMPOSE
OFF
AUTO
8 GREY BACK
OFF
ON
8 DIMMER
BRIGHT
DIMMED1
DIMMED2
OFF
8 POWER SAVE
OFF
ON
Page 93
You can select the modes of indications superimposed on the TV screen.
OFF:
To turn off superimposed indications.
AUTO:
To superimpose operational indications for approximately five
seconds just after the corresponding operation.
NOTES:
When you use this unit as the source player for editing, be sure to set "SUPERIMPOSE"
to "OFF" before starting. (
pg. 81, "Edit To Or From Another Recorder")
When you select "AUTO", during playback, the operation mode indicators may be
disturbed depending on the type of disc being used.
When this function is set to "ON", the TV screen becomes all grey when
receiving a channel not in use.
NOTE:
When you want to receive an unstable channel with poor signals, set this function to
"OFF".
You can change the brightness of the front display panel.
BRIGHT:
Normally select this.
DIMMED1/DIMMED2:
To change the brightness level.
OFF:
To dim the front display panel.
NOTE:
It is impossible to turn off the light of the front display completely. When "BRIGHT" or
"DIMMED1" is selected, the brightness level will be same as "DIMMED1" after the unit is
turned off. When "DIMMED2" or "OFF" is selected, the brightness level will be same as
"DIMMED2" after the unit is turned off.
When this function is set to "ON", you can reduce the power consumption
while the unit is turned off.
NOTES:
During Power Save mode —
— the front display panel will be turned off.
— the Just Clock function (
pg. 102) does not work.
Power Save does not work when —
— the unit is in the Timer mode.
— the unit's power is turned off after timer-recording or Instant Timer Recording.
— the Automatic Satellite Programme Recording mode is engaged. (
— "L-2 SELECT" is set to "DECODER", "SAT VIDEO" or "SAT S-VIDEO". (
It takes some time for the unit to complete initialisation after you turn on unit power,
with "WAKE UP" blinking on the front display panel.
Masterpage:Right-No-Heading
93
pg. 65)
pg. 83)
April 2, 2004 11:21 am
Advertisement
Table of Contents
