Kenmore 141.16688800 Use And Care Manual page 14

Install Ignitor Battery
[] Unscrew Ignitor Cap from Control Panel.
[] Place supplied AA battery into the Ignitor
Slot with positive pole facing you.
[] Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
Install Cooking Components
[] Place the Heat Diffusers above the
Burners.
[] Place the Cooking Grids on the ledge
above the Heat Diffuser.
[] Place the Secondary Cooking Rack into
the holes on the upper left and right of
the Back Burner frame with the bottom
resting in the slots on either side of
the Grill Bowl.
[] Place the Griddle above the Side Burner.
Ignitor Slot
f
AA Battery_
Ignitor Cap , "......
Spring
[]
[]
[]
[]
With the assistance of another person,
perform this Electrode Check before
proceeding.
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily
and properly.
Be sure all Control Knobs are set to
"OFF" and open the Grill Lid.
Have your assistant stand behind to the
right of the grill and look toward the front
of the grill bowl. Never put your face
inside the Grill Head.
Press the Ignitor Cap. You should hear
a "clicking" sound. Your assistant should
see a blue spark within each Gas
Collector Box. If a spark is present the
Electrode Tips are properly positioned.
If no spark is seen, the Spark Gap
needs to be adjusted as follows:
• If the gap between the Spark Elec-
trode Tip and Receiver is more than
3/16" use an adjustable wrench to
gently squeeze the Gas Collector Box
to narrow gap.
• Recheck the Electrode again, if no
"clicking" sound is heard:
- AA Battery may be installed back-
wards.
- Electric wires may be loose. Remove
the AA Battery and inspect the Ignitor
Junction Box found behind the Control
Panel and reconnect any loose wires.
Secondary Cooking Rack
Cooking Grids
Heat DiffUS_rokirng Grid/Infrared
Griddle
3/16"
Spark Gap Gas Collector
i!._ / Box
J ff I
' Spark Electrode Tip
Spark Receiver
14