Exhaust Duct System Components; Attaching The Appliance Adapter Spigot; Attaching Exhaust Duct Lengths; Attaching Exhaust Duct Vertical Roof Terminal - Rinnai RD-400AU Operation & Installation Manual

Gas dryer
Table of Contents

Advertisement

EXHAUST DUCT SYSTEM COMPONENTS:

DSFSPIGOT
A
Appliance adapter spigot (supplied with appliance).
DSFPIPE1000
B
Duct pipe 1000mm and stand-off clip
(installed length 950mm, can be cut to length as required
DSVCOWL
C
Vertical roof terminal 1060mm and stand-off clip
(installed length to exhaust outlet 900mm).
DSFBEND
D
Pair of 45° elbows.
DSFPLATE
E
Internal wall plate.
DSHCOWL
F
Horizontal wall terminal.
VENT
G
Air vent, provides an open area of 250 cm² (x 2).
DSVKIT, Vertical Exhaust Duct Kit
DSFPIPE1000 x 2
B
DSFPLATE x 1
E

ATTACHING THE APPLIANCE ADAPTER SPIGOT

Locate and remove the two mounting screws from either side of
the discharge duct, top left rear corner of the dryer.
Retrieve the appliance adapter spigot DSFSPIGOT
shipped inside the drum of the dryer.
Attach the DSFSPIGOT
mounting screws removed earlier, so that the flange of the
spigot is seated flush with the top panel of the dryer.

ATTACHING EXHAUST DUCT LENGTHS

The exhaust duct components DSFPIPE1000
DSFBEND
, may be connected directly to the appliance
D
adapter spigot
.
A
With the female socket end facing down, slide the selected
exhaust duct component over the DSFSPIGOT
female socket fully engages the spigot by 50mm.
Fit further exhaust duct components as required, maintaining
the 'female socket end down' orientation for the entire duct run
to the termination. Ensure that each female socket fully engages
the male ends by 50mm.

ATTACHING EXHAUST DUCT VERTICAL ROOF TERMINAL

The DSVCOWL
is fitted directly to either a DSFPIPE1000
C
or DSFBEND
. Ensure that the female socket fully engages
D
the male end by 50mm.

ATTACHING EXHAUST DUCT HORIZONTAL WALL TERMINAL

The DSHCOWL
is fitted flush to the wall surface over a
F
35mm external wall penetration of a DSFPIPE1000
Secure the DSHCOWL
the wall flange.
Rinnai
INSTALLATION
DSVCOWL x 1
C
to the discharge duct using the two
A
using the 3 fixing holes provided in
F
g
).
DSHKIT, Horizontal Exhaust Duct Kit
DSFPIPE1000 x 1
B
DSFPLATE x 1
E
, which is
A
, and
B
until the
A
B
.
B
18
Dry-Soft® RD-400AU / RD-600AU Installation Manual
DSFBEND x 1
D
DSHCOWL x 1
F

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rd-600auDry-soft 4Dry-soft 6

Table of Contents