Table of Contents
Advertisement
Section 5: Customizing Your System
This section describes how to customize your system to your needs. Refer to this section for
detailed instructions on: programming access codes, setting the time and date, and adjust-
ing the keypad sounders and lights.
Programming
The master code (code 40) can be used to program system options, arm and disarm the sys-
Access Codes
tem and program other access codes. You can program up to 32 additional access codes
(01 through 32). You can change or program access codes at both PC55XXZ and LCD key-
pads. Other access codes, such as system supervisory and duress codes, are available. Con-
tact your installer for more information.
NOTE:
program unique numerical combinations for duress codes.
LCD5500Z Keypads
1. Press
2. Use the
3. Press
4. Scroll to the code you want to program using the
5. To select a code for editing, press
6. Enter the new [code]. All codes must be four digits unless otherwise indicated by your
7. To exit access code programming, press
8. Record your new codes on the 'System Information' page (p.25) in this booklet.
PC55XXZ and LCD5501Z Keypads
1. Press
2. Enter the two-digit number of the access code you want to program (01-32 for access
3. Enter the new [code]. Access codes must be four digits unless otherwise indicated by
4. To exit access code programming, press
5. Record your new codes on the "System Information" page in this booklet.
Erasing a code:
1. Press
2. Enter the number of the code you want to erase [01 to 32]. The Master code cannot be
3. To erase the code, press
4. To exit access code programming, press
20
To program duress codes, contact your installer. It is the installer's duty to
to enter the function list.
keys to scroll to "Press (*) for <> Access Codes".
. The keypad will display "(*) to Edit User Code 01P".
beside the code number (e.g., [01P]), that code has already been programmed. If there
is no "P", then no code is programmed for that access code number. If an access code
already exists for the code number you select, it will be replaced by the new code.
installer. Enter digits 0 through 9 only. Once the code has been entered, the keypad will
beep 3 times. NOTE: Do not use the factory default or obvious codes such as [1111] or
[1234]. The keypad will display "(*) to Edit User Code 01P".
[Master Code]. The Program indicator flashes.
codes, 40 for master code). If an access code already exists for the code number you
have selected, it will be replaced by the new code.
your installer. Enter digits 0 through 9 only. NOTE: Do not use the factory default or
obvious codes such as [1111] or [1234].
[Master Code]
erased.
. The keypad will display "Enter New Code < >".
.
.
.
.
keys. If there is a letter "P"
Advertisement
Table of Contents
