Table of Contents
Advertisement
Chapter 2: Web Configuration
Security
This page is used to change the password that enables you to access the gateway web pages
cablelabs
admin
next time. The default User ID is
, and the password is
. The password can be a
maximum of 8 characters and is case sensitive. In addition, this page can be used to restore the
gateway to its original factory settings. Use this with caution, as all the settings you have made
will be lost. To perform this reset, set Restore Factory Defaults to Yes and click Apply. This has
the same effect as a factory reset using the rear panel reset switch, where you hold in the switch
for 15 seconds, then release.
After proper configuration, click Apply to invoke the settings.
Diagnostics
This page offers basic diagnostic tools for you to utilize when connectivity problems
occur. You may use the ping diagnostics or trace route function, just enter the
information needed and press Start Test; the Result will be displayed in the lower part of
the window. Press Abort Test to stop, and Clear Results to clear the result contents.
36
Advertisement
Table of Contents
