Advertisement
Controls & Functions
The OSD menu activates when you press the "1" button. Use either
the "UP" button to move your selection up or "DOWN" button to move
your selection down.
When a sub-menu is present you can use either the "UP" or "DOWN"
buttons to select the function you would like to modify.
button to save the value. Press either the "UP" or "DOWN" to make
another selection or press "1" to exit the OSD.
Below is a description of what each function will do:
Memory Recall
Selecting this function will reset the Contrast and Bright-
ness levels, Size, Position, Geometry to factory preset
values.
Pincushion
Select this function, then use the "UP/DOWN" buttons
to straighten the sides of the image by pulling them in
opposing directions.
Trapezoid
Select this function, then use the "UP/DOWN" buttons
to even the widths of the top and bottom of the display
(pulling the sides in opposing directions).
Parallelogram
Select this function, then use the "UP/DOWN" buttons to
center the top and bottom of the display (puuling the sides
in the corresponding direction)
Pin Balance
Select this function, then use the "UP/DOWN" buttons to
straighten the sides of the image by pulling them in the
corresponding direction.
Picture Tilt
Select this function, then use the "UP/DOWN" buttons to
rotate the image until the sides of the image are parallel
to the edge of the bezel.
5
Use the "2"
Advertisement
