Advertisement
Installation
No tools are required to install the SC190. Simply follow the
instructions outlined in the next few pages.
Connect Power Cord
Connect the female end of the power cable to the power input
receptacle on the back panel of the SC190. Then, plug the
male end of the power cable into an AC outlet. (see figure 1.1)
Connect Signal Cable
Attach the loose end of the signal cable to the graphics card. Be
cautious in inserting the cable properly into the graphics card. if
the cable does not seem to fit, it may be facing the wrong direc-
tion. Turn the cable over and try to match the shape of the con-
nector with that of the graphics card.
1
2
Power On
Switch ON the power to both the SC190 and your computer.
There will be a short delay before the display appears.
Base of Unit
Assemble the tilt/swivel base onto the bottom of the monitor.
Turn the monitor for a comfortable viewing angle within 80
degrees horizontally and 20 degrees vertically.
3
(Figure 1.2)
1: AC Input
The Power Cord is inserted
here.
2: Video Cable
The Video Cable plugs into
the back of your computer.
Advertisement
