Operating External Components With The Remote Control; Operating The Tv; Operating The Dbs Tuner Or Catv Converter - JVC TH-C6 Instructions Manual

Operating external components with the remote control

The buttons described below are used on pages 14 and
15.
TV/VIDEO
TV VOL
REC
TV RETURN
NOTE
• Manufacturers' codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.

Operating the TV

To set the manufacturer's code
You can operate a JVC TV without setting the manufacturer's code.
1
Slide the remote control mode selector
to TV.
2
Press and hold
Keep the button pressed until step 4 is finished.
3
Press ENTER.
TV VCR/DBS
VCR DBS
CHANNEL
Remote control
TV
mode selector
VCR/DBS
(play button)
ENTER
Number
buttons
100+
TV.
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV:
Press 1, then 0.
For a Toshiba TV:
Press 0, then 8.
JVC 01
Hitachi 10
Magnavox 02
Mitsubishi 03
Panasonic 04, 11 Zenith
RCA 05
5
Release TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
TV:
Turns TV on and off.
TV VOL +/–:
Adjusts the volume.
TV/VIDEO: Selects the input mode (either TV or
VIDEO).
CHANNEL +/–: Changes the channels.
1-10, 0, +10 (100+): Selects the channel.
TV RETURN:
Alternates between the previously selected
channel and the current channel.
Operating the DBS tuner
or CATV converter
To set the manufacturer's code
1
Slide the remote control mode selector
to VCR/DBS.
2
Press DBS.
3
Press and hold
Keep the button pressed until step 5 is finished.
4
Press ENTER.
Samsung 12
Sharp 06
Sony 07
Toshiba 08
09
VCR/DBS.
14