Troubleshooting - JVC LET0091-001A Instructions Manual

Other Information

Troubleshooting

64
What appears to be a malfunction may not always be serious. Please go through
the following list before requesting service.
Symptom
Power does Power plug is not inserted
not come on. securely.
Remote control Too far from the player.
does not work.
The tip of the remote unit is
not pointed in the right
direction.
Batteries are exhausted.
Battery polarity is incorrect.
No picture is Connection of video cable is
displayed on incorrect.
the monitor.
Input selection of TV is incorrect. Select correctly.
Disc is not playable.
No audio is Connection to stereo system
reproduced. is incorrect.
Input selection of amplifier
is incorrect.
No sound from PHONES LEVEL is too low.
headphones.
Sound is Disc is dirty.
distorted or
noise is
player is connected to
generated.
a VCR.
Picture is
garbled.
Picture does MONITOR TYPE is not
not fit with the correctly set.
television
Television is not correctly set.
screen.
Operation is Microcomputer malfunctions
not possible. due to lightning or static
electricity.
Moisture condensation occurs
by sudden change of
temperature or humidity.
The TV DOWN MIX is set to OFF.
speakers do
not reproduce
dialogs for a
DVD movie
disc.
There may be causes other than the player. Check the other devices connected to
the player.
Possible cause
Plug in securely.
Come closer to the player.
Point the infrared light-
emittingwindow toward the
remote sensor on the front panel.
Replace the batteries with new
ones.
Take out the batteries and
insert them again in the correct
direction.
Connect the cable correctly
(see page 9).
(See page 16.)
Check connections
(see Page 9 to 13).
Select correctly.
Adjust the PHONE LEVEL.
Wipe the disc surface
(see page 59).
Connect player with the
TV directly.
See "MONITOR TYPE"
on page 55.
Set the television correctly.
Turn off the power, then
connect the power cord again.
Turn off the power,
then turn it on a few hours
later.
Set DOWN MIX to L0/R0
(see page 33).
Remedy