JH
REMOVING THE DIFFERENTIAL
Remove the O-ring.
Tap the lip seal using a drift and a small hammer to
pivot it.
Remove the seal, taking care not to damage the
splines of the sunwheel.
Use the press to fit a small board under the
crownwheel to act as a support. Press on the clutch
housing to release the circlip (A) and remove it.
The differential comes out when the sunwheel is
pushed on the press.
MANUAL GEARBOX
Repairing the gearbox
REPLACING THE BEARINGS
Crownwheel side
Insert a small bar into the casing and place it flat on
the bearing.
Press on the press with a tube and extract the bearing.
REFITTING
The bearing race (C) must be facing the opposite side
to the crownwheel.
Drive the bearing home on the press, using tool
B. Vi. 1059 and resting on the outer ring of the
bearing.
19812
21-23
21