Table of Contents
Advertisement
I
O
U
NSTALLING THE
UTDOOR
NIT
Connecting the Cables to the Outdoor Unit
Type A
Type B
Type C
14
E-
Two electric cables must be connected to the outdoor unit:
The assembly cable connecting the indoor unit to the outdoor unit.
The power cable connecting the auxiliary circuit breaker to the
outdoor unit.
1
Remove the terminal board cover on the side of the outdoor unit.
2
Connect the assembly cable with the power cable such as figure.
Each wire is labelled with the corresponding terminal number.
Ensure the wire number of the indoor unit and the terminal
number of the outdoor unit.
3
Connect the earth wires to the earth terminals.
Refer to the page opposite for further details on how to check
that earthing is correct.
4
Replace the terminal board cover, carefully tightening the screw.
5
Connect the power cable to the auxiliary circuit breaker.
Specially for Russian and European market, before installation,
the supply authority should be consulted to determine the
supply system impedance to ensure compliance.
Hide quick links:
Advertisement
Table of Contents
