Panasonic TC-P54Z1 Operating Instructions Manual page 7

Accessories/Optional Accessory
Connect Wireless Unit (Transmitter) to Tuner Box
Exclusive cable
for Wireless
Transmitter
■
Cable Binding for Wireless Unit
Wireless Unit (Receiver) Wireless Unit (Transmitter)
Note
Do not connect any other device than Wireless Unit to the HDMI terminal of the Display Unit/Tuner Box.
Connect the Exclusive cable for Wireless Transmitter which has ferrite core to Tuner Box side.
If the connection is not correct, the following icons will be displayed when the Display unit and the Tuner box are
turned on.
This Display Unit is connected to a device other than Tuner Box.
12
Hole for Cable
clamper
ferrite core
Attach to hole for Cable
clamper
Unlock it and connect
the AV cable out of
the Exclusive cable
for Wireless Receiver/
Transmitter.
Fix the cable so that it will
not become unplugged.
(Continued)
Installing the Display Unit, Tuner Box and Wireless Unit
transmitter can be adjusted
approx. 10 m
Precautions for Wireless Unit
Transmission Range
Use the Wireless Unit (Transmitter) within a straight line distance of 10 m (approx.) from the Wireless Unit (Receiver).
The range may be shortened if there are any obstacles or the surrounding environment or building structure affects
the transmission.
Installation Environment
Do not install this apparatus in the following locations to avoid distortion of image or audio or unit failure due to the
radio performance degradation.
Location subject to be high temperature (near the heater etc.)
Location with poor air circulation (at the end of a closed rack etc.)
In the following cases, the image or audio may be distorted or intermittent, or the apparatus may not operate properly:
There is a strong obstacle for the radio waves between the Wireless Unit (Transmitter) and Wireless Unit (Receiver).
(furniture, AV devices, rack, rack door etc.)
Wireless Unit (Transmitter) is not facing the Wireless Unit (Receiver).
Wireless Unit (Transmitter) is placed significantly far from the front of Wireless Unit (Receiver) direction.
(Especially in a high position near the TV display, behind the TV, behind the right side of the pedestal)
Interference from Other Devices
If the Wireless Unit (Transmitter)/Wireless Unit (Receiver) is too close to other devices, failures such as malfunction
or slow remote control response may occur due to the radio wave interference.
Keep the transmitter away from the following devices as much as possible:
Wireless LAN, Microwaves, Telephones, Other electric devices
Note
When the signal state is poor and the power lamp of the Wireless Unit (Transmitter) / Wireless Unit (Receiver) is lit
red, communication may not be able to be performed again automatically (no video and audio output).
In such a case, turn the power off and then on again with the remote control.
Side View
5 m
45° Transmitter
Display
Receiver 45°
5 m
40°
Floor
5 °
The angle of the
[Vertical Direction]
to 40º upward and 5º Transmitter
Top View
downward.
10 m
80° 80°
5 m
5 m
Receiver
Display
[Horizontal Direction]
13