Table of Contents
Advertisement
14
EN
Auto Set Up
The Auto Set Up simplifies installation by guiding you
through the procedures of setting the clock and tuner
channels – simply follow the on-screen menus that appear.
Slide to the
right.
Before starting, make sure of the following:
● The TV aerial cable should be connected to the unit.
● The unit's mains power cord should be connected to a
mains outlet.
● The "Video Channel Set" (
and the TV should be set to its AV mode (with AV
connection
pg. 9) or UHF channel (with RF connection
pg. 9).
● Slide the TV/VCR/DVD switch on the remote control to the
right.
A
Turn on the unit.
Press 1 on the unit or remote control. The Language
Select screen appears on the TV screen.
B
Select language
Press rt to place the pointer next to your desired
language (English, Russian or Arabic), then press ENTER
or e.
● The Clock Set screen appears.
C
Set the date and time.
Press rt to set the time,
then press ENTER or e. The
"DATE" display begins
blinking. Repeat the same
procedure to set the date and
year.
● When you set the time/date,
press and hold rt to change
the time by 30 minutes/15
days.
pg. 13) should be performed
INITIAL SETTINGS (cont.)
D
Select the TV system.
Press rt to place the pointer next to the appropriate TV
system (refer to the table below).
Major Countries/Areas
Australia, New Zealand, Kuwait,
U.A.E., Indonesia, Singapore,
Thailand, Malaysia, Iran, Saudi Arabia,
Egypt, Morocco, Lebanon, Iraq
China, Mongolia, Russia
Hong Kong
E
Start Auto Channel Set.
Press ENTER or e.
DO NOT press any button on the unit or remote
control while Auto Set Up is in progress.
Auto Channel Set is performed next. Auto Channel Set scans
all the channels that are receivable by your unit. During Auto
Channel Set, the channel numbers are displayed as they are
scanned and set.
● As Auto Set Up progresses, the
"q" mark on the TV screen
moves from left to right.
● When Auto Set Up is
completed, the lowest position
number will appear on the front
display panel. If "SCAN
-
COMPLETED
NO SIGNAL
diplayed on the TV screen,
make sure that the aerial cable
is connected to the unit properly and press ENTER on the
remote control. The unit will try Auto Set Up again.
NOTES:
● If there is a power cut, or if you press 1 or SET UP while Auto
Set Up is in progress, Auto Set Up will be interrupted; be sure
to turn off the unit power once and try again from step A.
● If no sound accompanies the picture or the audio sounds
unnatural on some channels that have been stored by Auto Set
Up, the TV system setting for those channels may be incorrect.
Select the appropriate TV system for those channels.
—
"TV System Selection
audio can't be heard or sounds unnatural"
ATTENTION
If you perform Auto Set Up successfully during installation,
there's no need to separately perform the Clock Set or
Channel Set procedures, but if adjustments become
necessary, they can be performed as follows:
● Tuner setting
pg. 60
● Clock setting
pg. 19
TV System
B/G
D/K
I
AUTO CH SET
PLEASE WAIT
START
❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚ ❚
-
– – – – – – –
" is
When you see the picture but the
pg. 63).
FINISH
Advertisement
Table of Contents
