How To Set Function - Mitsubishi Heavy Industries SRK25ZJ-S Technical Manual

How to set function

Stop air-conditioner and press
1.
buttons at the same time for over three seconds, and the
"FUNCTION SET
2. Press
3. Make sure which do you want to set, "
(remote controller function) or "I/U FUNCTION
unit function).
4. Press
Selecct "
FUNCTION
5. Press
- -
Hi - Lo Hi - Me 6. On the occasion of remote controller function selection
UH - Me UH - Hi
7. Press ON/OFF button.
Setting is finished.
How to check the current setting
When you select from "No. and funcion" and press set button by the previous operation, the "Setting" displayed first is the current
setting.
(But, if you select "ALL UNIT
(SET)
" will be displayed.
(SET) button.
or button.
FUNCTION " (remote controller function) or "I/U
" (indoor unit function).
(SET) button.
"DATA LOADING" (Indication with blinking)
Display is changed to "01 GRILLE SET".
Press or button.
"No. and function"are indicated by turns on the remote
controller function table, then you can select from them.
(For example)
Function No.
Function
Press (SET) button.
The current setting of selected function is indicated.
(for example) "AUTO RUN ON" If "02 AUTO RUN SET" is
selected
Setting
Press or button.
Select the setting.
Press (SET)
"SET COMPLETE" will be indicated, and the setting will be
completed.
Then after "No. and function" indication returns, Set as the
same procedure if you want to set continuously ,and if to
finish, go to 7.
It is possible to finish by pressing ON/OFF button on the way, but unfinished change of setting is
unavailable.
During setting, if you press
Setting is memorized in the controller and it is saved independently of power failure.
", the setting of the lowest number indoor unit is displayed.)
Operation message
Function description:
(MODE)
setting description:
FUNCTION "
" (indoor
1
6
Indoor unit selection button
On the occasion of indoor unit function selection
"DATA LOADING" (Blinking for 2 to 23 seconds to read the data)
Indication is changed to "02 FAN SPEED SET".
Go to
[Note]
(1) If plural indoor units are connected to a remote controller,
the indication is "I/U 000" (blinking)
the indoor unit connected is indicated.
(2) Press
Select the number of the indoor unit you are to set
If you select "ALL UNIT
all unites.
(3)
Press
Press
"No. and function" are indicated by turns on the indoor unit function
table, then you can select from them.
(For example)
Press
The current setting of selected function is indicated.
(For example) "STANDARD"
selected.
Press
Select the setting.
Press
"SET COMPLETE" will be indicated, and the setting will be
completed.
Then after "No. and function" indication returns, set as the same
procedure if you want to set continuously , and if to finish, go to 7.
When plural indoor units are connected to a remote controller,
press the AIRCON NO. button, which allows you to go back to
the indoor unit selection screen. (example "I/U 000
(RESET) button, you return to the previous screen.
94
- -
P J A 0 1 2 D 7 2 9 A
,
Function No.
Fixing button
7 Finishing button
2 Starting button
Previous screen button
.
The lowest number of
or button.
", you can set the same setting with
(SET) button.
or button.
Function No.
Function
(SET) button.
If "02 FAN SPEED SET" is
Setting
or button.
(SET) button.
'10 • SRK-T-098
")