Table of Contents
Advertisement
03 Climate control
Fuel-driven engine block heater and passenger compartment heater*
With the direct start of the heater it will be acti-
vated for 50 minutes.
Heating of the passenger compartment will
begin as soon as the engine coolant has
reached the correct temperature.
03
NOTE
The car can be started and driven while the
parking heater is running.
Setting the timer
The time when the car shall be used and heated
is specified with the timer.
Select between
TIMER 1
1. Scroll with the thumbwheel to
HEAT TIMER --:-- ON
2. Give a long press (approx. 2 seconds) on
the RESET button in order to access the
flashing time setting.
3. Select the required hour using the thumb-
wheel.
4. Briefly press RESET to move to the flash-
ing minutes setting.
5. Select the required minute using the
thumbwheel.
6. Briefly press RESET to confirm the setting.
*
94
Option/accessory, for more information, see Introduction.
7. Press RESET to activate the timer.
After setting
be programmed with
the thumbwheel.
Set the alternative time in the same way as
TIMER 1
Deactivating a timer-started heater
A timer-started heater can be switched off
manually before the set time has elapsed. Pro-
ceed as follows:
1. Press the READ button.
2. Use the thumbwheel to scroll to the text
PARK HEAT TIMER 1
and
TIMER 2
.
TIMER 2
PARK
The text
.
3. Press RESET.
The text
glow and the heater is switched OFF.
A timer-started heater can be switched off in
accordance with the instructions in the section
"Direct start and immediate stop".
Clock/timer
The heater's time is connected to the car's
clock.
TIMER 1
a second start time can
TIMER 2
by scrolling with
.
or
PARK HEAT
.
ON
flashes on the display.
OFF
is shown with a constant
NOTE
All timer programming will be cleared if the
car's clock is reset.
Advertisement
Table of Contents
