Table of Contents
Advertisement
06 Starting and driving
Alcolock*
Bypass function will then be possible, see
page 148 section Emergency situation.
The message can be cleared by pressing the
send button (3) once. Otherwise it goes out on
its own after approx. 2 minutes but then reap-
pears each time the engine is started - only
recalibration at a workshop
sage permanently.
Cold or hot weather
The colder the weather the longer it takes
before the Alcolock is ready for use:
Temperature (ºC)
+10 to +85
-5 to +10
06
-40 to -5
At temperatures below -20 ºC or above
+60 ºC the Alcolock requires additional power
supply. The display shows
INSERT POWER CABLE
nect the power supply cable from the glovebox
and wait until indicator lamp (6) is green.
2
An authorised Volvo workshop is recommended.
*
148
Option/accessory, for more information, see Introduction.
In extremely cold weather the heating time can
be reduced by taking the Alcolock indoors.
Emergency situation
In the event of an emergency situation or the
Alcolock is out of order, it is possible to bypass
the Alcolock in order to drive the car.
2
can clear the mes-
NOTE
All Bypass activation is logged and saved in
memory, see page 10 in the section,
Recording data.
After the Bypass function has been activated
Maximum heat-
the display shows
ing time (sec-
ENABLED
onds)
can only be reset by a workshop
10
The Bypass function can be tested without the
60
error message being logged - in which case,
carry out all the steps without starting the car.
180
The error message is cleared when the car is
locked.
When the Alcolock is installed, either the
Bypass or Emergency function is selected as
ALCOGUARD
the bypassing option. This setting can be
. In which case, con-
changed afterwards at a workshop
ALCOGUARD BYPASS
the whole time while driving and
2
.
2
.
Activating the Bypass function
•
Depress and hold the left-hand stalk
switch READ button and the button for
hazard warning flashers simultaneously for
approx. 5 seconds - the display first shows
BYPASS ACTIVATED WAIT 1 MINUTE
ALCOGUARD BYPASS
and then
ENABLED
- after which the engine can be
started.
This function can be activated several times.
The error message shown during driving can
2
only be cleared at a workshop
.
Activating the Emergency function
•
Depress and hold the left-hand stalk
switch READ button and the button for
hazard warning flashers simultaneously for
approx. 5 seconds - the display shows
ALCOGUARD BYPASS ENABLED
the engine can be started.
This function can be used once, after which a
reset must be made at a workshop
and
2
.
Advertisement
Table of Contents
