Chevrolet Captiva OM C140 Manuals page 335

16. If the flat tyre was able to inflate
to the recommended inflation
pressure, remove the maximum
speed label from the sealant
canister (5) and place it in a
highly visible location.
Do not exceed the speed on this
label until the damaged tyre is
repaired or replaced.
17. Return the equipment to its
original storage location in the
vehicle.
18. Immediately drive the vehicle 8
km (5 miles) to distribute the
sealant in the tyre.
19. Stop at a safe location and check
the tyre pressure. Refer to Steps
1 through 11 under "Using the
Tyre Sealant and Compressor Kit
without Sealant to Inflate a Tyre
(Not Punctured)."
If the tyre pressure has fallen
more than 68 kPa (10 psi) below
the recommended inflation
pressure, stop driving the vehicle.
The tyre is too severely damaged
and the tyre sealant cannot seal
the tyre.
If the tyre pressure has not
dropped more than 68 kPa (10
psi) from the recommended
inflation pressure, inflate the tyre
to the recommended inflation
pressure.
20. Wipe off any sealant from the
wheel, tyre or vehicle.
21. Dispose of the used sealant
canister (5) and sealant/air hose
(7) assembly at a local dealer or
in accordance with local
regulations and practices.
22. Replace it with a new canister
available from your dealer.
Vehicle care 333
23. After temporarily sealing a tyre
using the tyre sealant and
compressor kit, take the vehicle
to an authorised dealer within a
161 km (100 miles) of driving to
have the tyre repaired or
replaced.