Basic Playback; Turning The Player On And Off; Initial Setup - JVC 0204STYBICJSC Instructions Manual

Basic playback

STANDBY/ON
STANDBY/ON indicator
5/∞
About invalid operation icon
When you press a button, and if the player does not accept its
operation, appears on your TV screen. Operations are
occasionally unacceptable even if
Note that some operations may not be accepted. For example,
some discs may not allow rapid advance/reverse or slow-
motion playback.

Turning the player on and off

Press STANDBY/ON
unit or press STANDBY/ON on the front
panel.
The STANDBY/ON indicator on the front panel, which lights
in red during standby, goes off.
The opening display appears on the TV screen, and the following
messages may appear at the bottom of the opening display.
NOW READING
Message area
STANDBY/ON
ENTER
is not displayed.
on the remote control
• NOW READING (The player is reading the disc information.)
• REGION CODE ERROR! (The region code of the DVD VIDEO
disc does not match the player. The disc cannot be played
back.)
• CANNOT READ THIS DISC (The disc cannot be played back
by the player.)
• OPEN (The disc tray is opening.)
• CLOSE (The disc tray is closing.)
• NO DISC (No disc is loaded.)
NOTES
• Even if you turn off the player, the player is not disconnected
from the AC power source as long as it is connected to the wall
outlet. This state is called standby mode. In this state, the player
consumes a very small amount of power.
• You can change the picture of the opening display. (See page
22.)

Initial setup

When you turn on the player for the first time after purchase, the
following message appears on the TV screen.
EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO
SETTING
YES - PRESS ENTER NO - PRESS CANCEL
You can set the display language, TV monitor type and digital
output before using the player, by following the procedure below.
1
Press ENTER.
The first page of the DVD PLAYER SET UP display appears.
The pull-down menu of the [ON SCREEN LANGUAGE] is
already open.
DVD PLAYER SET UP
MENU LANGUAGE
AUDIO LANGUAGE
SUBTITLE
ON SCREEN LANGUAGE
SELECT USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
TO EXIT, PRESS SETUP.
ON SCREEN LANGUAGE options
2
Press 5/∞ to select the desired language.
You can select the on-screen language for the preference
displays, etc. from among ENGLISH, FRENCH and
GERMAN.
3
Press ENTER.
The second page is shown, in which the pull-down menu of
the [MONITOR TYPE] is already open.
DVD PLAYER SET UP
MONITOR TYPE
PICTURE SOURCE
SCREEN SAVER
BACK GROUND
SELECT USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
TO EXIT, PRESS SETUP.
MONITOR TYPE options
4
Press 5/∞ to select the desired monitor type.
For a normal (conventional) TV, select [4:3 LB] or [4:3 PS].
For a wide-screen TV, select [16:9]. (See page 24.)
ENGLISH
ENGLISH
ENGLISH
ENGLISH
ENGLISH
FRENCH
GERMAN
4:3 L.B.
16:9
AUTO
4:3 LB
4:3 PS
ON
STANDARD
7