JBL EON 210P User Manual page 10

4. Connect the Mixer Module to the Speakers
On the right side of the mixer you will notice two ¼" phone jacks – these are your speaker output jacks.
Take the speaker cables and connect them from these jacks to the jacks on the back of the speakers.
Left speaker
output jack
EFFECT MENU
1 Effect Bypass: This turns all
effects off
2 Plate Reverb: Use with Vocals
and Acoustic Instruments
3 Room Reverb: Use with
Vocals, Acoustic and Electric
Instruments, Percussion,
Piano and General Applications
4 Slapback: Short Echo with
Repeats. For Lead Vocal,
Karaoke, Rockabilly
5 Large Hall Reverb: Use with
Lead Vocals, Brass or
Strings
Rev F
Right speaker
output jack
Connecting the AC Power Cable
Connect the female end of the power cable to the mixer and plug
the male end into the wall socket or extension cord. Turn the "MASTER VOLUME" control to "0".
Now turn the power switch to the "on" position. You should see the "POWER" indicator illuminated.
EFFECT MENU
1 Effect Bypass: This turns all
effects off
2 Plate Reverb: Use with Vocals
and Acoustic Instruments
3 Room Reverb: Use with
Vocals, Acoustic and Electric
Instruments, Percussion,
Piano and General Applications
4 Slapback: Short Echo with
Repeats. For Lead Vocal,
Karaoke, Rockabilly
5 Large Hall Reverb: Use with
Lead Vocals, Brass or
Strings
Rev F
10
To Left speaker
October 5th, 2010
To Right speaker
To Left speaker
October 5th, 2010
To Right speaker
EFFECT MENU
1 Effect Bypass: This turns all
effects off
2 Plate Reverb: Use with Vocals
and Acoustic Instruments
3 Room Reverb: Use with
Vocals, Acoustic and Electric
Instruments, Percussion,
Piano and General Applications
4 Slapback: Short Echo with
Repeats. For Lead Vocal,
Karaoke, Rockabilly
5 Large Hall Reverb: Use with
Lead Vocals, Brass or
Strings
E300993 37TY
AC power inlet
&
voltage selector switch
October 5th, 2010
Rev F