Side / Rear - JVC VN-V25U Instructions Manual

Getting Started

Side / Rear

J
[MONITOR OUT] Monitor Output Selection
Switch
Use this switch to select the availability of output
from the N [MONITOR OUT] terminal as well as
the signal system.
NTSC : Outputs NTSC signals.
OFF : No output. Select this value when
distributing images to the network.
PAL : Outputs PAL signals.
[Default setting: OFF]
Caution:
● Images are not distributed to the network
when ANTSCB or APALB is selected.
● When the switch is changed, press the K
Reset button to reboot the unit.
K
[RESET] Reset Button
This is a button for rebooting the camera. Press
this button and release within 5 seconds to
reboot the camera.
It takes about one minute for the camera to
reboot. During startup, the [RESET] button is
disabled.
Note:
Pressing the [RESET] button for 5 seconds or
longer switches the camera to the service
verification mode. Do not press the button for 5
seconds or longer.
L
[IRIS] Iris Terminal
Use this terminal to connect the DC iris lens.
(Connection with the video iris lens is not
possible.)
(A Page 13)
M
[STATUS] Status Indicator
This status of this product is indicated in green
or orange color.
Starting up: Lights up in orange
Startup complete: Lights up in green
Error: Blinking (orange or green)
10
J K
MONITOR OUT PAL OFF NTSC
RESET
STATUS
IRIS
M L
Q
1 2
AC24V
MONITOR
OUT
SEE INSTRUCTION MANUAL
CAUTION
PoE
: NEVER USE
DO NOT CONNECT TO THE TELEPHONE NETWORK
N O
Note:
You can adjust the [LED State] settings via the
network to turn off the indicator after startup is
complete. (A Page 65)
N
[MONITOR OUT] Monitor Video Signal
Output Terminal (RCA)
This is an output terminal for composite video
signals (1 V (p-p), output impedance of 75 K).
Use this terminal to connect to devices such as a
video monitor.
This terminal is used for adjusting the camera
angle during installation. (A Page 16)
Note:
● Use the J [MONITOR OUT] switch to select
the availability of output as well as the signal
system. When the switch is changed, press
the K Reset button to reboot the unit.
● When using the [MONITOR OUT] output, set
the privacy mask to AOffB. (A Page 50)
O
[10BASE-T/100BASE-TX]
Use this terminal to connect to the network via a
LAN cable.
This product supports PoE (IEEE802.3af class 2)
and therefore can be used without a power cable.
(A Page 14)(A Page 16)
P
[ALARM INPUT/OUTPUT] Alarm Input/
Output Terminals
Use these terminals to connect to an external
alarm device.
(A Page 17)
Q
[AC24V] Power Input Terminal
Use this terminal to connect to an AC 24 V,
50/60 Hz power supply.
(A Page 15)
R
Fall Prevention Wire Mounting Screw
(M3 x 6 mm)
Use this screw to mount the fall prevention wire.
(A Page 18)
P
G 2 1 2 1
R
ALARM
10BASE-T/
100BASE-TX
AC 24V
AND AT THE SAME TIME
PUSH