Page 1
www.skylinkhome.com Emergency Dialer DIAL-ALERT MODEL: ED-100 If you would like to order Skylink’s products or have difficulty getting them to work or download information and user manual, please : 1. visit our FAQ section at www.skylinkhome.com, or 2. email us at support@skylinkhome.com, or 3.
Page 2
SKYLINK TECHNOLOGIES INC. Your Guide to the Emergency Dialer DIAL-ALERT MODEL: ED-100 The ED-100 Emergency Dialer contains all the above items. – –...
PACKAGE CONTENTS ADDITIONAL ACCESSORIES All materials required for installation are included with this package Additional transmitters as well as add on accessories are available to work with your Dial-Alert. 1 Dial-Alert (AD-105) 1 Telephone Line Water Resistant Panic Button Transmitter (PT-434) 1 antenna (installed) - Activates Security Control Panel and Emergency 1 AC adapter...
PANIC TRANSMITTER BATTERY OVERVIEW The Panic Transmitter operates on three 3-volt lithium batteries (CR-1220) The AD-105 Dial-Alert can call multiple telephone numbers and sends a that are installed at the factory. The battery storage life of these lithium personalized pre-recorded message. The person receives the emergency batteries is approximately five years.
INSTALLATION BATTERY MAINTENANCE The Dial-Alert is installed using the screws provided. We have also included The ED-100 Dial-Alert comes with 1 battery that at some point you may double sided tape, to use for temporary installation while you are positioning have to replace: the dialer.
Page 7
ADVANCED PROGRAMMING INSTALLATION Arming / Disarming 2. Thread the telephone line through the top hole in the back of the unit and plug it into To arm the dialer, simply enter the password and then press “ ”. The the "LINE" jack. If you want to have an ARM LED will be on.
Page 8
ADVANCED PROGRAMMING INSTALLATION Speaker On/Off Switch 2. Enter [0], display now shows [P0 2], the most right digit represents The speaker must be on during pro- the dial sequence. gramming and recording the voice 3. To change the setting, enter either 1 or 2, where 1 is Dial Sequence 1, message in order to use the playback and 2 is Dial Sequence 2.
ADVANCED PROGRAMMING LIGHTS AND SOUNDS Erase Programmed Panic Transmitters / Alarm Panels / Sensors Below is an explanation of the lights and sounds of the Dial-Alert You may erase the programmed wireless devices, panic transmitter, alarm LIGHTS panels and wireless sensors. You cannot erase a specific device, you must ACPWR light on dialer is being powered by AC adapter.
STANDARD PROGRAMMING ADVANCED PROGRAMMING There are a few programming steps you must perform before the dialer can Changing Password operate. Please follow the instructions below to program these fields, including: Password is required for programming purposes. Factory default is 0000. - Record voice messages To change the setting, follow the instructions below.
OPERATIONS STANDARD PROGRAMMING When the display shows “rEAdy”, that means the unit is in standby mode. MESSAGE PLAYBACK It will dial when it receives a panic signal from the alarm panel, or its own If you would like to listen to the recorded message, you can playback the panic button is pressed.
PANIC TRANSMITTER STANDARD PROGRAMMING The Panic Transmitter conveniently fits on any keychain or necklace. It Do not program the phone number to police or fire dept directly into your Dial-Alert allows you to activate the Dial-Alert from a distance of approximately 100 feet unless you have checked with your local authorities.