Controls, Connectors And Indicators - JVC TK-C1431 Instructions Manual

INTRODUCTION

Controls, Connectors and Indicators

Lens mount
1
To attach the lens.
This is applicable to both C-mount lenses
and CS-mount lenses.
Back focus adjustment ring
2
Adjusting the back focus during lens
installation.
When readjustment is required, loosen
the locking screw by turning it
3
counterclockwise and turn the back focus
adjustment ring .
2
After the adjustment, tighten the locking
screw again.
3
[BF LOCK] Back focus locking screw
3
This serves to fix the back focus-adjusting
ring.
E-8
Camera-mounting bracket
4
The bracket has been attached on the
bottom of the camera before shipment. It
can also be attached on the top
according to the circumstance.
To re-attach the bracket use the threaded
holes at the top, with the camera
mounting bracket fixing screws .
7
Camera-mounting screw
5
hole (1/4 inch)
Use this hole when mounting
the camera onto a fixer, pan/
MAX.
7
mm
tilt unit, and the like. (Use a
screw shorter than 7 mm.)
Rotation-preventive hole
6
Make use of this rotation-preventive hole
to prevent any fall when mounting the
camera. Always make sure that the
camera is securely mounted.
Camera mounting bracket fixing screws
7
(×2: M2.6 × 6 mm)
Be sure to use a 6 mm long screw.
SET
CAMERA
SETUP
AWC
MENU
Cover
8
The cover slides open when push to the
left.
[VIDEO/DC] Iris Selector Switch
9
This should be set according to the type
of lens if an automatic iris control lens is
used.
VIDEO: In case of lens with EE amp built-
in.
DC: In case of lens without EE amp
built-in.
(DC: At time of factory shipment)
[IRIS] Iris Terminal
10
This is connected to an automatic iris
control lens.
( Page 15)
[MENU] Menu Button
11
When pressed, a menu screen is brought
up.
( Page 23)
EXT TERM-OFF ON
LL
INT/GL
SIMPLEX
DUPLEX
RX TERM-OFF ON
NOT USED
IRIS
VIDEO
DC
[SET/AWC] Set. Auto White Control
12
Button
SET: Press this button to display a sub-
menu.
( Page 23)
AWC: If this button is kept pressed for
more than 1 second, a one-push-
auto-white-balance function works
and sets the white balance. Once
it is set, even if colour temperature
changes, white balance does not
change. It is also possible to make
fine adjustments on the set white
balance.
( Page 22)
E-9