No Signal Off; No Operation Off - Sharp Aquos LC-37D6U Operation Manual

Basic adjustment settings
Power control setting allows you to save energy.
No signal off
When set to "Enable", the power will automatically shut
down if no signal inputs for 15 minutes.
Press MENU and the MENU screen displays.
Press
<llllII/~
to select "Power Control".
This setting allows you to optimize the settings of Digital
broadcasting.
You can output digital audio to an AV amplifier or similar
device whose DIGITAL AUDIO INPUT terminal is
connected to the DIGITAL AUDIO OUTPUT terminal
on the TV (see page 30). Please select an audio output
format compatible with the audio format of the program
you are watching and the equipment connected.
Press MENU and the MENU screen displays.
Press
./T
to select "No Signal Off", and
then press ENTER.
Press
<llllII/~
to select "Enable", and then
press ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
• "Disable" is factory preset value.
• When a TV program finishes, this function may not operate.
No operation off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
Press
~/~
to select "Digital Setup".
Press
./T
to select "Audio Setup", and then
press ENTER.
Press
./T
to select "PCM" or "Dolby
Digital", and then press ENTER.
Repeat steps 1 and 2 in No signal off.
Press
./T
to select "No Operation Off", and
then press ENTER.
The optical output terminal outputs
audio signal by PCM form. If your
digital audio system does not
support Dolby Digital, select
"PCM".
The optical output terminal outputs
audio signal by Dolby Digital form.
It reproduces sound from surround
program of digital.
PCM
Dolby Digital
Press
<llllII/~
to select "Enable", and then
press ENTER.
• Five minutes before the power shuts down,
remaining time displays every minute.
~
fID
• "Disable" is factory preset value.
@-28