Sharp Aquos LC-37D6U Operation Manual page 17

@-16
Watching TV
You can change channels in several ways by pressing
AIR or CABLE to select the antenna and then following
one of the methods below .
•••
•••
•••
•••
AIR CABLE INPUT FI..ASItlACK
• • 0 .
tJ v~ ~H
SURROUND . MUTE
o -
0
Method 1
Using CH/\fV on the remote control unit or on the TV.
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
• FLASHBACK will not work if no channel has been
changed after TV is turned on.
Method 3
Using remote control buttons 0-9, •
(DOT) to select
channels for VHF/UHF/CATV/OIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5~
ENT
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1~1~5
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2
~2-?
(DOT) -? 1
~
ENT
I~
~at.
• When you enter
0-9
only, channel selection will be made
if there is no operation for a few seconds .
• If you push "0" by itself, nothing will happen.
• Complete the above steps within a few seconds.
• When you enter 0-9 and • (DOT), channel selection will
be made if there is no operation for a few seconds.