Auto Image - Hitachi CP-WU13K User Manual

H Start
‡
Use W X WR DGMXVW WKH SURMHFWHG LPDJH¶V KRUL]RQWDO SRVLWLRQ
If the projected image is not at the center of the screen (i.e. shifted to right or left) and
HQGV XS EHLQJ FURSSHG XVH WKLV IXQFWLRQ WR DGMXVW WKH LPDJH¶V KRUL]RQWDO SRVLWLRQ 7KH
following image is an example of test image from an external signal source:
Native picture
H Phase
‡
Use W X WR DGMXVW WKH SURMHFWHG LPDJH¶V SKDVH
Use this function to adjust the phase of pixel sampling clock (relative to input signal).
6KRXOG WKH LPDJH VWLOO ÀLFNHU RU VKRZ QRLVH LH HGJHV RQ WH[WV DIWHU RSWLPL]DWLRQ DGMXVW
phase accordingly.
V Start
‡
Use W X WR DGMXVW WKH SURMHFWHG LPDJH¶V YHUWLFDO SRVLWLRQ
If the projected image is not at the center of the screen (i.e. shifted up or down) and ends
XS EHLQJ FURSSHG XVH WKLV IXQFWLRQ WR DGMXVW WKH LPDJH¶V YHUWLFDO SRVLWLRQ 7KH IROORZLQJ
image is an example of test image from an external signal source:
Native picture
It is recommended that when adjusting the image, the horizontal total should be adjusted before the horizontal phase. However, if
WKH LPDJH VWLOO ÀLFNHUV HYHQ DIWHU \RX KDYH DGMXVWHG ERWK WU\ ORZHULQJ WKH LPDJH QRLVH

Auto Image

When Auto Image was selected in the OSD menu, press
adjustment function.
By executing this function, the projector will resync the image. Use this function when the
image source is unstable or when you notice deterioration in image quality and the projector will
automatically adjust the image size, phase and timing. (The adjustment also applies to PIP input
source).
This function is identical to the
the remote control to execute this function.
Skewed left
Skewed down
ENTER
button on the remote control. You can simply use the hot key on
OSD Menu description
Skewed right
Skewed Up
to execute the automatic image
39