Turning On The Projector; Changing Osd Language - Hitachi CP-WU13K User Manual

Installation of the Projector
3D mode
There are few ways to go to the 3D mode
‡ OSD menu: Go to Main Menu "Input > Input Selection", and select STEREO DVI
‡ Remote control: Press hot key "5" to go to STEREO DVI directly
‡ Network Webpage: Go to "Source/general" > "Source" and select STEREO DVI
‡ RS232 Commands : Use " Input Selection" to select STEREO DVI
When this function is blanking. The 3D Mode is not available
2D mode
Please note that OSD menu is not available in 3D mode. The ways to switch back to 2D mode are:
‡ Remote control: Press any of the input key 1-4 will switch back to 2D mode.
‡ Network Webpage: Go to "Source/general" > "Source" and select any other source that are
available.
‡ RS232 Commands: Use " Input Selection" to select any other source that are available.

Turning on the projector

Refer to the instructions covered in

Changing OSD language

By factory default, the OSD menu of the projector is displayed in English. If you wish to
switch to a different language, you can go to
choose the language you prefer for the OSD.
24
" Page 15 : Installation the projector. ".
MENU
Æ CONTROL Æ Language and