Numeric Error Codes - Lenovo T420 Maintenance Manual

Table 2. Numeric error codes (continued)
Symptom or error
0191
System Security—Invalid Remote Change requested.
0199
System Security— Security password retry count
exceeded.
0251
System CMOS checksum bad— Default coniguration
used.
0271
Real-time clock error. Check date and time settings.
1802
Unauthorized network card is plugged in—Turn off and
remove the miniPCI network card.
1820
More than one external ingerprint reader is attached.
Power off and remove all but the reader that you set up
within your main operating system.
2000
Hard Drive Active Protection sensor diagnostics
failed.Press <Esc> to continue.Press <F1> to enter
SETUP
2100
Detection error on HDD0 (Main HDD)
2101
Detection error on HDD1 (Ultrabay HDD)
2102
Detection error on HDD2 (Mini SATA)
2110
Read error on HDD0 (Main HDD)
2111
Read error on HDD1 (Ultrabay HDD)
2112
Read error on HDD2 (Mini SATA)
2200
Machine Type and Serial Number are invalid.
2201
Machine UUID is invalid
46
ThinkPad T420 and T420i Hardware Maintenance Manual
FRU or action, in sequence
1. Run ThinkPad Setup Utility, and then save current
setting by pressing F10.
2. System board.
1. Run ThinkPad Setup Utility, and then save the
current setting by pressing F10.
2. System board.
1. Charge the backup battery for more than 8 hours
by connecting the ac power adapter.
2. Replace the backup battery and run ThinkPad Setup
Utility to reset the time and date.
Run ThinkPad Setup Utility to reset the time and date.
1. Remove Mini PCI network card.
2. System board.
Remove all but the reader that you set up for the
authentication.
1. Undock docking station or port replicator if it is
attached to the ThinkPad Notebook.
2. Place the ThinkPad Notebook on a horizontal surface.
Do not apply any physical shock to the computer.
3. Run Diagnostics ➙ ThinkPad Devices ➙ HDD
Active Protection Test.
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Ultrabay hard disk drive.
3. System board.
1. Reseat the Mini SATA device.
2. Mini SATA device.
3. System board.
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Ultrabay hard disk drive.
3. System board.
1. Reseat the Mini SATA device.
2. Mini SATA device.
3. System board.
System board.
System board.