Electrolux EWM1000 Service Manual page 45

Alarm Description
E61 Insufficient heating during washing
E62 Overheating during washing
E66 Heating element power relay faulty
E71 Washing NTC sensor faulty
E82 Error in selector reset position
E83 Error in reading selector
E93 Incorrect configuration of appliance
E94 Incorrect configuration of washing cycle
Communications error between
E95
microprocessor and EEPROM
Incongruency between hardware version
E96
and configuration
Incongruency between programme selector
E97
and cycles configuration
EB1 Incorrect frequency of appliance
EB2 Voltage too high
EB3 Voltage too low
SOI/DT 2002-07 eb
Possible fault
NTC sensor faulty; heating element faulty; wiring faulty; PCB
faulty.
NTC sensor faulty; heating element faulty; wiring faulty; PCB
faulty.
PCB faulty; current leakage from heating element to ground.
NTC sensor faulty; wiring faulty; PCB faulty.
PCB faulty.
(Incorrect configuration data); PCB faulty.
Incorrect configuration data; PCB faulty.
Incorrect configuration data; PCB faulty.
PCB faulty.
Incorrect configuration data; PCB faulty.
Incorrect configuration data; PCB faulty.
Power supply problems (incorrect / disturbance); PCB faulty.
Power supply problems (incorrect / disturbance); PCB faulty.
Power supply problems (incorrect / disturbance); PCB faulty.
45
Action/machine status
The heating phase is skipped
Safety drain cycle – Cycle stopped
with door open
Safety drain cycle – Cycle stopped
with door open
The heating phase is skipped
---
Cycle cancelled
Cycle interrupted
Cycle interrupted
Cycle interrupted
Cycle interrupted
Cycle interrupted
Cycle interrupted
Cycle interrupted
Cycle interrupted
Reset
---
OFF
OFF
Start
OFF
---
OFF
OFF
OFF
OFF
OFF
---
---
---
599 35 36-69