Wiring Conversion - Danfoss TS715 Si Installation & User's Instructions

WIRING CONVERSIONS,
Wiring conversions for other timeswitches which can be replaced with the
Danfoss TS715-Si, refer to the second part of the table. If in any doubt, please
contact our Technical Services Department before proceeding with the
replacement.
DANFOSS RANDALL
TS715-Si
The existing wallplate may be used when replacing the following, but the wiring must be
between L & COM terminals of wallplate.
ACL LS111, LS711, LP111 & LP711
DRAYTON TEMPUS ONE & TEMPUS TWO
LANDIS & GYR RWB3
LANDIS & GYR RWB30
The TS75/TS15 wallplate must be used to replace the existing wallplate when replacing th
age systems, fi t wire link between terminal 1 & L of wallplate.
GRASSLIN 45, 45A, 45E
HONEYWELL ST6100
HORSTMANN 423 PEARL, EMERALD & TOPAZ
HORSTMANN KMK2A YMK2
HORSTMANN 425 CORONET
DANFOSS RANDALL 911
DANFOSS RANDALL 103, 103E, 103E5 & 103E7
RANDALL 3020
DANFOSS RANDALL SET1
RANDALL TSR2
PEGLER SUNVIC SP20 & SP25/30
POTTERTON MYSON EP4001
8
(applies only to 230 volt models)
MAINS
N L
N L
N L
N L
N L
N L
2 1
N L
N L
3 4
N L
N L
5 6
1,7 6
N L
3 2
N L
N L