JVC GR-D225 Instructions Manual page 31

Warning Indications
Displays the battery remaining power.
Remaining power level
High
As the battery power comes close to nil, the battery
indicator blinks.
When the battery power is exhausted, power turns off
automatically.
Appears when no tape is loaded. (
CHECK TAPE'S ERASE PROTECTION TAB
Appears when the erase protection tab is set to "SAVE"
while the Power Switch is set to "A" or "M". (
USE CLEANING CASSETTE
Appears if dirt is detected on the heads during recording.
Use an optional cleaning cassette. (
CONDENSATION, OPERATION PAUSED
PLEASE WAIT
Appears if condensation occurs. (The two indications
above swiches alternately every 3 seconds.) When this
indication is displayed, wait more than 1 hour until
condensation disappears.
TAPE!
Appears if a tape is not loaded when the Recording Start/
Stop Button or SNAPSHOT Button is pressed while the
Power Switch is set to "A" or "M".
TAPE END
Appears when the tape ends during recording or
playback. ( pg. 27)
SET DATE/TIME!
Appears when the date/time is not set. (
Appears when the built-in clock (lithium) battery is
discharged and the previously set date/time is erased.
( pg. 8)
LENS CAP
Appears for 5 seconds after power is turned on if the lens
cap is attached.
COPYING FAILED
Appears if dubbing of copyguarded signals is attempted
while this camcorder is being used as a recorder.
E01, E02 or E06
UNIT IN SAFEGUARD MODE REMOVE AND
REATTACH BATTERY
The error indications (E01, E02 or E06) show what type
of malfunction has occurred. When an error indication
appears, the camcorder turns off automatically. Remove
the power supply (battery, etc.) and wait a few minutes for
Exhausted
the indication to clear. When it does, you can resume
using the camcorder. If the indication remains, consult
your nearest JVC dealer.
E03 or E04
UNIT IN SAFEGUARD MODE EJECT AND REINSERT
TAPE
pg. 9)
The error indications (E03 or E04) show what type of
malfunction has occurred. When an error indication
appears, the camcorder turns off automatically. Eject the
cassette once and re-insert it, then check if the indication
pg. 8)
clears. When it does, you can resume using the
camcorder. If the indication remains, consult your nearest
JVC dealer.
pg. 33)
pg. 8)
TROUBLESHOOTING
EN
31