Table of Contents
Advertisement
Warning!
With the engine not running, there
is no power assistance for the
braking and steering systems. In
this case, it is important to keep in
mind that a considerably higher
degree of effort is necessary to brake
and steer the vehicle.
Note:
To signal turns while being towed with
hazard warning flasher in use, turn key
in steering lock to position 2 and
activate combination switch for left or
right turn signal in usual manner - only
the selected turn signal.
Upon canceling the turn signal, the
hazard warning flasher will operate
again.
Jump Starting
Warning!
Failure to follow these directions will
cause damage to the electronic
components, and can lead to a
battery explosion and personal
injury.
Never lean over batteries while
connecting or jump starting, you
might get injured.
Battery fluid contains sulfuric acid.
Do not allow this fluid to come in
contact with eyes, skin or clothing. In
case it does, immediately flush
affected area with water, and seek
medical help if necessary.
A battery will also produce hydrogen
gas, which is flammable and very
explosive. Keep flames or sparks
away from battery, avoid improper
connection of jumper cables,
smoking etc..
Read all instructions before
proceeding.
If the battery is discharged, the engine
should be started with jumper cables
and the (12 V) battery of another
vehicle.
The battery is located in the trunk
behind the right-hand cover panel.
Proceed as follows:
1. Position the vehicle with the
charged battery so that the
jumper cables will reach, but
never let the vehicles touch.
Make sure the jumper cables do
not have loose or missing
insulation.
2. On both vehicles:
• Turn off engine and all lights
and accessories, except hazard
flashers or work lights.
• Apply parking brake and shift
selector lever to position "P".
125
Hide quick links:
Advertisement
Table of Contents
