Table of Contents
Advertisement
Replacing Bulbs
When replacing bulbs, install only 12
volt bulbs with the specified watt
rating.
When replacing halogen bulbs do not
touch glass portion of bulb with bare
hands. Use plain paper or a clean cloth.
Warning!
Halogen lamps contain pressurized
gas. A bulb can explode if you
•
touch or move it when hot,
•
drop the bulb,
•
scratch the bulb.
Bulb for Low Beam (Xenon)
Warning!
Because of high voltage in Xenon
lamps, it is dangerous to replace the
bulb or repair the lamp and its
components. We recommend that
you have such work done by a
qualified technician.
Bulb for High Beam H1 (55 W)
Open hood.
Depress latch (7) and remove
cover (6).
Pull off electrical connector (9).
Unhook clamping ring and remove
bulb.
Insert new bulb (seating properly in
cutouts of bulb socket), and mount
clamping ring. Reinstall and push
electrical connector on securely.
Reinstall bottom end of cover (6) and
push against top end of cover until
properly seated.
Check lamp for proper operation.
Turn Signal, Parking, Side
Marker and Standing Lamp
(2375 NA [28.5/8.3 W/ 30/2.2 cp] bulb)
Open hood.
Turn bulb socket (5) with bulb
counterclockwise and pull out. Push
bulb into socket, turn counterclockwise
and remove.
Insert new bulb in socket, push in and
twist clockwise. Reinstall bulb socket,
push in and twist clockwise.
119
Hide quick links:
Advertisement
Table of Contents
