Ice Machine Heat Of Rejection; Removing Drain Plug And Leveling The Ice Storage Bin; Air Baffle - Manitowoc S Installation, Use & Care Manual

Installation Instructions

Ice Machine Heat of Rejection

Series
Ice Machine
Air Conditioning
S300
S320
S420
S450
S500
S600
S850
S1000
S1200
S1400
S1600
S1800
S3300
B.T.U./Hour
Because the heat of rejection varies during the ice making cycle,
the figure shown is an average.
Ice machines, like other refrigeration equipment, reject
heat through the condenser. It is helpful to know the
amount of heat rejected by the ice machine when sizing
air conditioning equipment where self-contained air-
cooled ice machines are installed.
This information is also necessary when evaluating the
benefits of using water-cooled or remote condensers to
reduce air conditioning loads. The amount of heat added
to an air conditioned environment by an ice machine
using a water-cooled or remote condenser is negligible.
Knowing the amount of heat rejected is also important
when sizing a cooling tower for a water-cooled
condenser. Use the peak figure for sizing the cooling
tower.
6
Heat of Rejection
Peak
5000 6000
3800 6000
5900 6900
5900 6900
6100 6900
9000 13900
13000 16000
17700 21000
20700 24500
23500 27000
21000 31000
30000 35000
45000 51000
Removing Drain Plug and Leveling the Ice
Storage Bin
1. Remove threaded plug from drain fitting.
2. Screw the leveling legs onto the bottom of the bin.
3. Screw the foot of each leg in as far as possible.
! Caution
The legs must be screwed in tightly to prevent them
from bending.
4. Move the bin into its final position.
5. Level the bin to assure that the bin door closes and
seals properly. Use a level on top of the bin. Turn the
base of each foot as necessary to level the bin.
6. Inspect bin gasket prior to ice machine installation.
(Manitowoc bins come with a closed cell foam
gasket installed along the top surface of the bin.)
7. Remove all panels from ice machine before lifting.
and installing on bin. Remove both front panels, top
cover, left and right side panels.

Air Baffle

SELF-CONTAINED AIR-COOLED ONLY
The air-cooled baffle prevents condenser air from
recirculating. To install:
1. Remove the back panel screws next to the
condenser.
2. Align the mounting holes in the air baffle with the
screw holes and reinstall the screws.
Section 2
AIR
BAFFLE
Part Number 000006520 11/11