Transmit Power Select; Scanning - Uniden UH720SX-NB Owner's Manual

Operation

Transmit Power Select

7KH 8+6;1% KDV WKUHH WUDQVPLW SRZHU OHYHOV  :DWW  :DWW DQG  :DWW
7KH 8+6;1% KDV WKUHH WUDQVPLW SRZHU OHYHOV  :DWW  :DWW DQG  :DWW
7R FKDQJH \RXU WUDQVPLW SRZHU OHYHO
1. Press while in the 'power middle level' to change to 'power high level.'
2. Press while in the 'power high level' to change to the 'power low level.'
3. Press while in the 'power low level' to change to 'power middle level.'
TX Power Low
Transmitting on a higher level will use more Battery power but
will enable you to transmit further.
NOTE

Scanning

The UH710SX-NB/UH720SX-NB has two types of scanning; Open Scanning
(OS) and Group Scanning (GS), OS Scan searches all the channels and
frequencies in its memory continuously. GS Scan is
similar to OS scan but has the added ability to monitor
the priority channel every 1.5 seconds.
Scanning allows you to search for active
channels programmed in the OS or GS memory.
To initiate scanning,
1. Assuming the unit is on CH01 when switched on.
2. Press and scanning starts.
SCAN ÀDVKHV GXULQJ VFDQQLQJ
UNIDEN UH720SX-NB/UH710SX-NB
TX Power Middle
15
TX Power High
UHF CB Radio