Call Epg Menu; Selection Of Provider/Station; Switch On Tv At Memo - Loewe Xelos A 26 Operating Instructions Manual

Modes of operation – EPG
Programming recording for recorders
You prepare the station marked with the
pressing the red button. In the following menu you confirm the timer data
or change them as required. Then a red dot is set in front of this program
in the EPG program list as an identifi cation. If you select this program, you
can delete the program from the timer again with the red button.

Call EPG menu:

Call EPG menu
EPG menu
Select provider/channel
You will fi nd the following settings in the EPG menu:
• select provider/channel • Timer overview
• Switch on TV when marked

Selection of provider/station

In case of analog TV programs, you can change the provider (the station
which transmits EPG data) to have other programs evaluated. You can do
this under "Select provider/channel".
Select "Select provider/channel" and call this menu with OK. If the station
you want to change to is not listed in the "Select provider" list, start the
provider search with the green button. This takes a while.
Or, if you know the station, press the yellow button for "Change provider
list". Select the provider in the program list and enter it with OK and return
to the provider selection with END.
Select the provider in the "Select provider" and enter with OK. Then a
program range search is performed. The programs offered by the provider
are displayed in a list.
If you want certain programs to be omitted from the program guide, you
can select and deactivate these in the Program selection. Call the pro-
gram selection with the blue button. Now all programs are displayed (the
DVB programs too). Programs marked by E are analog terrestrial/cable pro-
grams, programs marked by D are digital programs ready for the program
guide. Select the programs you want to omit from the program guide one
after another and deactivate each one with OK.
18
buttons for recording by
INFO END
Timer overview Data capture Switc
OK
• Data capture
Data entry
After these settings or every time the switch is set off with the mains
switch, the data must first be collected (only for analog TV). To do this,
select the program which you have defi ned as a provider and leave it
switched on for about 1 hour or switch the set to standby. The indicator on
the TV set lights orange after about 2 minutes. The data entry begins and
lasts about 1 hour. The data are also automatically collected between 2 and
5 in the morning when the TV is switched to standby.
A prerequisite for data entry is that "Data capture" is "on" in the EPG
menu.
Note: If the TV set is switched off with the mains switch or the plug is
pulled out, all EPG data are lost.
If you cannot receive any EPG providers, for example, you should switch off
the data entry.
Switch on TV when marked
You can have the TV switched on automatically from standby at the begin-
ning of the memorized program. If you are not present at the time, a safety
prompt makes sure the TV switches off again after 5 minutes.