Brake Pad Replacement - Honda NX250 Shop Manual

HYDRAULIC BRAKE
Pump up the system pressure with the brake lever until there
are no air bubbles in the fluid flowing out of the reservoir small
hole.
Connect the bleed hose to the bleed valve and bleed the
system as follows:
NOTE
- Do not release the brake lever until the bleed valve has been
closed.
2. Release the brake lever slowly and wail several seconds
aftrer it reaches the end of its travel.
Repeat steps 1 and 2 until air bubbles cease to appear in the
fluid coming out of the bleed valve.
Tighten the bleed valve.
TORQUE: 6 N-m (0.6 kg-m, 4.3 ft-lb)
Fill the mster cylinder resevoir to the upper level mark with
DOT 4 brake fluid from a sealed container.
Install the diaphragm, sei plate and reservoir cover.
Tighten the reservoir cover screws.
TORQUE: 1.5 N-m (0.15 kg m, 1.1 ft-lb)
BRAKE PAD/DISC

BRAKE PAD REPLACEMENT

NOTE
• Always replace the brake pads in pairs tc assure even disc
Push the caliper pistons all the way into caliper to gain clear-
ance for the new pads.
CAUTION
- Be careful thai the master cylinder does no! overflow when the
caliper pistons are compressed.
face.
Remove the following:
— pad pin plug
— pad pin
- pads
14-4
PAD PIN