Table of Contents
Advertisement
the dust and piston seals in and lift them out.
; - 7 an the seal grooves with clean brake fluid.
•
Be careful not to damage the piston sliding surfaces.
SERVICE LIMIT: 26.89 mm (1,0587 in)
Measure the caliper cylinder inside diameter.
SERVICE LIMIT: 27.06 mm (1.065 in)
ASSEMBLY
The dust and piston seals must be replaced with new ones
whenever they are removed.
Coat new dust and piston seals with clean biake fluid and in-
stall them in the seal grooves in the calipei.
Lubricate the caliper cylinders and pistons with clean brake
fluid and install the pistons into the caliper cylinders as shown.
HYDRAULIC BRAKE
(2> DUST SEALS
" « •
14-9
Advertisement
Table of Contents
Troubleshooting
