Getting Started - Motorola VC6000 Series Product Reference Manual

Getting Started

In order to start using the VC6000 Series for the first time:
•
Install a SIM Card
•
Install a SD Memory Card
•
Install the VC6000 Series in a vehicle or on a desktop.
•
Start the VC6000 Series.
Installing a SIM Card
Before using the VC6096 in a cellular network, make sure that the VC6096 is equipped with a Subscriber Identity
Module (SIM) card, obtained form your service provider. The SIM card is a small smart card that fits into the
VC6096. The SIM card holds the personalized information about the VC6096, including network activation and
phone book entries.
To install the SIM card:
Remove the T8 screw that secures the SIM card door and open the door.
1.
Position the SIM card with the contacts facing the back of the VC6096, and insert into the SIM slot. The SIM
2.
card corner notch fits into the slot only one way (see
Use a pen to push the SIM card inwards to lock.
3.
Place the SIM card door and secure the T8 screw.
4.
NOTE The VC6096 powers on only if the T8 screw is fully secured.
Torque the T8 screw to 3.4 kgf-cm (3 in-lbs).
5.
SIM Card Installation
Figure 1-3
CAUTION
T8 Screw
Ensure to torque the screw to seal the VC6000 Series properly. Otherwise, sealing can be
compromised.
Figure 1-3).
SIM Slot
SIM Card
SIM Card Door
Getting Started 1 - 7