First Alert FA168CPS: FA148CP User Manual page 26

3DJLQJ)HDWXUH
$ERXW$XWRPDWLF3DJLQJ
Your system may be set up to automatically send alert messages to several pagers (up
to four for FA168CPS, up to two for FA148CP) as certain conditions occur in your
system.
• The following events can be programmed by your installer to be sent to the pagers:
• You can also program the system to send an automatic pager message to alert you
• Your installer programs the pager phone numbers and reporting events.
• The pager message consists of a 7-digit system status code that indicates the type of
• An optional, predefined 16-digit character string can precede the 7-digit system
• The pager display format is as follows:
Ex. 1.   ³    
Ex. 2.    ³     = Reporting of a closing–system arming (102)– by user 5 in Partition 2 (2005).
– 26 –
Technical Manuals Online! - http://www.tech-man.com
arming and disarming , alarms, and trouble conditions. (
†
arming/disarming from a keypad using a security code; auto-arming/disarming,
arming with assigned button, and keyswitch arming do not send pager messages.)
in the event that someone has not arrived home (disarmed the system) within a
defined period of time (see the Scheduling section for details on programming a
"latch key report").
condition that has occurred.
status code; these characters can consist of a PIN no., subscriber account no., or any
additional data that you may wish to have sent to the pager.
3-digit Event Code
Optional 16 digits
È È
AAAAAAAAAAAAAAAA – BBB – CCCC
A =
Optional 16-digits for A 3-digit code that
Account numbers, describes the event
PIN numbers, or any that has occurred
other data; in your system
programmed by the (see for event
installer, if required. codes table below)
The 3-digit Event Codes (BBB) that can be displayed are:
911 =
Alarms.
The 4-digit number The 4-digit number
(CCCC) following this (CCCC) following this
code is the partition no. code is the partition no.
and zone no. that and zone no. that
caused the alarm. caused the trouble.
= R eporting of an alarm (911) caused by a fault on zone 4 on Partition 1 (1004).
È È
Å Å
1-digit Partition No. + 3-digit Zone No. or User No.
B =
A 1-digit Partition number plus a 3-digit Zone or User
number, depending on the type of event that has
occurred, where:
• alarms and troubles display zone number
• arming/disarming (opens/closes) display user number
811 = 101 =
Troubles.
(system disarmed).
The 4-digit number
(CCCC) that follows
this code is the
partition no. and user
no. that disarmed the
system.
reports when
†
C =
102 =
Open Close
(system armed).
The 4-digit number
(CCCC) that follows
this code is the
partition no. and user
no. that armed the
system.