Download Print this page

Remington Smooth & Silky WDF4820AU Use & Care Manual

Rechargeable shaver smooth silky

Advertisement

Quick Links

CLEANING & MAINTENANCE
CARE FOR YOUR SHAVER
To ensure long lasting performance of your shaver, clean the head assembly
regularly. The easiest and the most hygienic way to clean the shaver is by
rinsing the shaving head after use with warm water. Always keep the protective
headguard on the shaving head when the shaver is not in use.
AFTER EACH USE
1. Ensure the shaver is turned off.
2. Press the release buttons to open the shaver head.
3. Blow on the foils to remove any loose debris.
4. Brush or rinse the accumulated hair from the main body of the shaver,
shaving head and cutter assembly.
5. Leave the head assembly open to let the shaver dry completely.
6. Return the shaving head to its original position and snap in place.
NOTE:
• Ensure that the shaver is turned off when cleaning.
• Do not clean the shaving foils with the brush.
• At regular intervals, put a drop of sewing machine oil onto the foils and cutters
heads.
REPLACING THE FOILS & CUTTERS
Signs that your foils and cutters need replacing:
Irritation: As foils get worn, you may experience skin irritation.
Pulling: As the cutters wear, your shave may not feel as close and you may feel
your cutter pulling on your hair.
Wear: You may notice that the cutters have worn through the foils.
To ensure the continued highest quality performance from your shaver, we
recommend that foils and cutters are replaced every 6 months.
7
TO REPLACE THE FOIL
1. Ensure the shaver is switched off.
2. Remove the shaver head.
3. Gently push the small plastic tabs area at either end
of the foil carrier. The foil carrier should then easily
tabs
detach from the shaving head.
4. To reassemble, snap the new foil carrier into position.
5. Attach the shaving head.
CAUTION
• Only hold the plastic to prevent damage to the foil.
new foil
• Do not press on the foil when replacing.
TO REPLACE THE CUTTERS
1. Ensure the shaver is switched off and open the shaving head.
2. To remove cutter, grasp cutter between thumb and forefinger and pull upward.
3. To reassemble cutter, place cutter onto oscillator tip. Gently push down
clicking into position.
Remington strongly recommends that an approved Safety Switch
(Residual current device) be installed to protect all bathroom
power outlets. Ask an electrical contractor for advice.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
Money Back Offer - Australia/New Zealand Only
If within 30 days you are not fully satisfied with your Remington® shaver,
just return the shaver with this completed coupon and a copy of your
Australian/New Zealand purchase receipt to Remington®. In return, we
will send you a cheque for the full purchase price of the shaver. Please
allow 6-8 weeks for your cheque to arrive.
Name:_________________________________________________
Address:_______________________________________________
City:_____________________ State:________ Postcode: ________
8
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited
WARRANTY AGAINST DEFECTS
In this warranty:
Australian Consumer Law means the Australian consumer law set out in Schedule 2
to the Competition and Consumer Act 2010;
CGA means the New Zealand Consumer Guarantees Act 1993;
Goods means the product or equipment which was accompanied by this warranty and
purchased in Australia or New Zealand, as the case may be;
Manufacturer, We or us means:
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd
ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited,
as the case may be, contact details as set out at the end of this warranty;
Supplier means the authorised distributor or retailer of the Goods that sold you the Goods
in Australia or in New Zealand; and
You means you, the original end-user purchaser of the Goods.
1. Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
2. The benefits provided by this Warranty are in addition to all other rights and remedies in
respect of the Goods which the consumer has under either the Australian Consumer Law
or the CGA. The original purchaser of the Goods is provided with the following Warranty
subject to the Warranty Conditions:
3. We warrant the Goods for all parts defective in workmanship or materials for the period
of two (2) years from the date of purchase (Warranty Period). If the Goods prove
defective within the Warranty Period by reason of improper workmanship or material, we
may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer's instructions. This
Warranty does not apply should the defect in or failure of the Goods be attributable to
misuse, abuse, accident or non-observance of manufacturer's instructions on the part of
the user. As far as the law permits, the manufacturer does not accept liability for any
direct or consequential loss, damage or other expense caused by or arising out of any
failure to use the Goods in accordance with the manufacturer's instructions.
5. Exhaustible components (such as shaver heads, cutters and foils) of the Goods
are included under this Warranty only where there is a defect in workmanship or
materials used.
6. The warranty granted under clause 3 is limited to repair or replacement only.
7. Any parts of the Goods replaced during repairs or any product replaced remain the
property of the manufacturer. In the event of the Goods being replaced during the
Warranty Period, the warranty on the replacement Goods will expire on the same date
as for the Warranty Period on the original Goods which are replaced.
9
7
8. In order to claim under the warranty granted under clause 3 you must:
(a) Retain this warranty with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid
freight within the Warranty Period accompanied with (i) the legible and unmodified
original proof of purchase, which clearly indicates the name and address of the
Supplier, the date and place of purchase, the product name or other product serial
number and (ii) this warranty.
9. This warranty is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
(b) The Goods have been serviced or otherwise repaired by a person not authorised to
do so by us or where non approved replaced parts are used.
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to any
industrial or commercial use of the Goods. The Goods must be connected to the electrical
voltage requirements as specified in the ratings label located on the Goods.
11. This warranty does not cover the cost of claiming under the warranty or transport of the
Goods to and from the Supplier or us.
12. This warranty is only valid and enforceable in Australia against Spectrum Brands
Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Chifley Business Park
1 Chifley Drive
Mentone, VIC 3194 Australia
Customer service in Australia: 1800 623 118
E-mail: consumer.enquiry@remington-products.com.au
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
Building C, Ground Floor
600 Great South Road,
Greenlane, Auckland 1051 New Zealand
Customer service in New Zealand: 0800 736 776
E-mail: info@remington.co.nz
Website: www.remington-products.com.au
REMINGTON SERVICE HOTLINE
Australia 1800 623 118 (toll free)
New Zealand 0800 736 776 (toll free)
AUTHORISED REPAIR CENTRES
Visit www.remington-products.com.au for Authorised repair centre details.
® Registered Trade Mark of Spectrum Brands Inc., or one of its subsidiaries
© 2012 SBI
Rev. 05/12
Part No. T22-0000279
10
8
RECHARGEABLE
SHAVER
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
2 YEAR WARRANTY
WDF4820AU / WDF4835AU
1

Advertisement

loading

Summary of Contents for Remington Smooth & Silky WDF4820AU

  • Page 1: Rechargeable Shaver

    Pulling: As the cutters wear, your shave may not feel as close and you may feel 4. The Goods must be used in accordance with the manufacturer’s instructions. This If within 30 days you are not fully satisfied with your Remington® shaver, your cutter pulling on your hair.
  • Page 2 3. Hold the shaver at a right angle to your skin and press down gently. from outlet. Before using your REMINGTON® shaver for the first time, charge for 20 hours. mental capabilities or lack of experience and knowledge if 4. Edge and shape the area as desired.

This manual is also suitable for:

Dd90 series